|
Attention, software does not include MX10 update, only for MX33!
Changes
- Speed controller flashes if the speed is not confirmed after repeated transmission.
- Invert O-W (east-west) also with RailCom (shift+dir key)
Bugfixes
- Unnecessary' entries removed from Obj config
- G'Fusy (E5) scroll direction inverted
- Display problems in radio mode corrected
- Optimised double button press
- Signal reception bar display for vehicle change fixed
- Signal reception bar II display for RailCom locomotives fixed
- Blue speedometer (without RailCom) now faster
- Optimisation of the direction change LED display
- Obj DB import works again
- GUI import from MX10
|
MX33_01.01.0080
Update for MX33 ONLY.
|
|
Attention, software does not include MX10 update, only for MX33!
Bugfixes
- Rocrail takeover/transfer
- Decoder info was sometimes not displayed
- Locos without RailCom appear with RailCom speedo
- Various other bug fixes
Changes
- Improved display logic of the RailCom direction LEDs
|
MX33_01.01.0070
Update for MX33 ONLY.
|
|
Attention, software does not include MX10 update, only for MX33!
Bugfixes
|
MX33_01.01.0063
Update for MX33 ONLY.
|
|
Attention, software does not include MX10 update, only for MX33!
Changes
- Radio improvements
- New dialogue for S/ H button combinations
- Progmode button X sets scroll wheel fine control mode for 1 second
- Pressing the scroll wheel increases/decreases the current CV value
- After change is saved when exiting fine control
- Panel mode (drive button W) Touch now for all turnouts
Bugfixes
- Radio controller jumps and other transfer errors
- Turnout panel layout
- Various bug fixes for radio operation
- Various errors with RailCom display or feedback
- Error regarding "Assign address"
- E2 dialogue safety warning on exit
- E2 Blue needle curve Set speed via touch on speedometer
- Fine control optimisation
- MX33 displays locomotive name, address and image during decoder identify
- Various display problems
- Locomotive takeover at system startup with several MX33s
- Crash when updating to very old beta version
- Update EFU
- Clone menu from active address
- Control button flickering
|
MX33_01.01.0058
Update for MX33 ONLY.
|
|
Attention, software does not include MX10 update, only for MX33!
Changes
Shift+U enables transfer from loco screen
Bugfixes
- Save GUI Speedo, GUI Update/Save
- Update EFU
- Prevent East-West flashing when changing direction on radio
- Behaviour of E-Mode when pressing the shift key
- GUI clone dialogue from active address
- If UID of CV #253 is zero, Identify aborts
- Control button flickering in position FS0
- New arrangement Panel Mode (no more panel name displayed)
- Decoder info positioning optimised
- Progmode button X sets scroll wheel fine control mode for 1 second
- Actuation of scroll wheel increases/decreases current CV value
- Change is saved when exiting fine control mode
- Panel mode (drive button W) touch now for all turnouts
|
MX33_01.01.0017
Update for MX33 ONLY.
|
|
This software version corresponds to the first delivered firmware of the MX33 controller.
(does not contain an MX10 update! Can be used as an update for MX33 beta versions).
Changes
Optimisations and various bug fixes (compared to beta versions) |
MX33_01.01.0001
Update for MX33 ONLY.
|